We manufacture a number of replacements for hard to obtain items in our own workshops:
Click thumbnails for larger images
 |
 |
 |
Fuel tank cradle, made from
stainless steel for the main cradle and ABS plastic for
the protection cover at the base of the tank. It also has
foam rubber on all surfaces that come into contact with
the tank as per the original.Price is £147.91 incuding all new fixings in stainless steel.
Fuel tank cradle in stainless steel
Intake rubbers made from
silicone reinforced with cotton, which
is resistant to oil/fuel contamination so will
therefore last much longer than the original Porsche
items.The kit includes all eight intake tubes, 16 new worm drive clips as per original but in silver zinc plate rather than the gold passivated, the lower plenum to throttle body tube and also (not shown in the picture) the small tube that joins the plenum to the Y piece that feeds the brake servo etc.
Cost is £58.55 p+p included.
New intake rubbers in oil-resistant silicone rubber
Bulkhead cover for early 928/928s 78-84
vacuum formed from ABS plastic. It is thicker than
the original and therefore much stronger,
the sealing rubber will still fit and just has to be
pushed a bit harder to locate it . There is also a lip
left on at the rear edge which sits under the rear
finisher and keeps it in place, the original doesn't have
this lip and relies on a spring clip for location. If you
want original then a pair of scissors will remove it.Cost is £17 p+p included.
Bulkhead cover vacuum formed from ABS plastic
Fuel pump / filter cover. Vacuum formed
from ABS plastic,this replaces the rusty original that is
to be found on most 928s. Looks just like the original
and uses the factory mountings.Cost is £15 p+p included.
Fuel pump/filter cover vacuum formed from ABS plastic
We also fabricate RMB exhausts for
928s. All are made from 316 stainless steel so therefore
will NOT rust ,attachment to the existing system is by
welding as per original. We are able to make exhausts to
your own design there is a limit on pipe size obtainable
but I am sure that none of you would want a 6"
tailpipe!Costs vary depending on what you require but S and S2 cars (right) are between £120 and £160 and S4 type are £120 to £200
RMB - S/S2 type
S4 type (right), costs £145 + p
& p.
RMB - S4 type
© 928spares.co.uk
